SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SUBURBAN K2500, 6.0 UREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1041 (ENGINE CONTROLS AND FUEL - 6.6L (LMM) - INTRODUCTION (2 OF 2))COMPONENT LOCATORENGINE CONTROLS CONNECTORSMASS AIR FLOW (MAF)/INTAKE AIR TEMPERATURE (IAT) SENSOR
2006 Chevrolet Suburban K2500, 6.0 U

Mass Air Flow (MAF)/Intake Air Temperature (IAT) Sensor

2006 Chevrolet Suburban K2500, 6.0 USECTION Mass Air Flow (MAF)/Intake Air Temperature (IAT) Sensor
WARNING: This page is about a different car, the 2007 GMC Sierra, 2007 GMC Cab & Chassis Sierra, 2007 Chevrolet Silverado, and 2007 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Mass Air Flow (MAF)/Intake Air Temperature (IAT) Sensor Connector End View
GM1399241Courtesy of GENERAL MOTORS CORP.
Mass Air Flow (MAF)/Intake Air Temperature (IAT) Sensor Connector Parts Information

Connector Part Information 
  • OEM: 15443141
  • Service: 19151506
  • Description: 5-Way F TS Series Sealed (BK)
Terminal Part Information 
  • Terminal/Tray: 8100-3455/2
  • Core/Insulation Crimp: 8/8
  • Release Tool/Test Probe: 15315247/J-35616-64B (L-BU)
Mass Air Flow (MAF)/Intake Air Temperature (IAT) Sensor Connector Terminal Identification

Pin Wire Color Circuit No. Function
1 0.5 YE 492 MAF Sensor Signal
2 0.5 GY/BK 2931 Low Reference
3 0.5 PK 1839 Ignition 1 Voltage
4 0.5 TN 2760 Low Reference
5 0.5 TN 472 IAT Sensor 1 Signal
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.