Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SUBURBAN K2500, 6.0 UREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1023 (KEYLESS ENTRY SYSTEM AND REMOTE FUNCTIONS)REPAIR INSTRUCTIONSTRANSMITTER BATTERY REPLACEMENTREMOVAL PROCEDURE
2006 Chevrolet Suburban K2500, 6.0 U
Removal Procedure
2006 Chevrolet Suburban K2500, 6.0 USECTION Removal Procedure
WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Insert a small bladed tool, at the slot provided near the key ring hole (5), between the two halves (6, 4) of the transmitter case.
- Twist the small bladed tool, between the two halves in order to separate the case.
- Remove the battery (2) from the transmitter.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.