Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SUBURBAN K2500, 6.0 UREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1012 (WIPER SYSTEM & WASHER SYSTEM)COMPONENT LOCATORWIPER/WASHER COMPONENT VIEWS
2006 Chevrolet Suburban K2500, 6.0 U
Wiper/Washer Component Views
2006 Chevrolet Suburban K2500, 6.0 USECTION Wiper/Washer Component Views
WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
| Callout | Component Name |
|---|---|
| 1 | Battery - Right |
| 2 | Windshield Wiper Motor |
| 3 | Windshield Washer Solvent Heater (XA7) |
| 4 | Fuse Block - Underhood |
| 5 | Battery - Left (Diesel/6A6/T92) |
| 6 | Washer Fluid Level Switch |
| 7 | Windshield Washer Fluid Pump |
| 8 | Air Cleaner Box |
| Callout | Component Name |
|---|---|
| 1 | Sunroof |
| 2 | Sunshade - Right |
| 3 | Outside Moisture Sensor (CE1) |
| 4 | Inside Rearview Mirror (ISRVM) Window Anchor |
| Callout | Component Name |
|---|---|
| 1 | Turn Signal Multifunction Switch |
| 2 | Ignition Lock Cylinder |
| 3 | Tow/Haul Switch |
| 4 | Steering Angle Sensor |
| 5 | A/T Shift Lock Control Solenoid |
| 6 | Theft Deterrent Control Module |
| 7 | Ignition Switch |
| 8 | Inflatable Restraint Steering Wheel Module Coil |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.