SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SUBURBAN K2500, 6.0 UREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1009 (WIRING SYSTEMS AND POWER MANAGEMENT - INTRODUCTION)REPAIR INSTRUCTIONSIGNITION LOCK CYLINDER CASE REPLACEMENTINSTALLATION PROCEDURE
2006 Chevrolet Suburban K2500, 6.0 U

Installation Procedure

2006 Chevrolet Suburban K2500, 6.0 USECTION Installation Procedure
WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Ignition Lock Cylinder & Screws
    GM1700676Courtesy of GENERAL MOTORS CORP.
  1. Install the ignition lock cylinder case (1) to the vehicle.
    2. NOTE: Refer to Fastener Notice .
  2. Install the 3 ignition lock cylinder case screws (2).

    Tighten:  Tighten the screws to 7 N.m (62 lb in).

  3. Install the park lock cable into the lock cylinder housing.
  4. Connect the passlock and key buzzer to the ignition lock cylinder case.
  5. Install the ignition/start switch. Refer to Ignition and Start Switch Replacement .
  6. Install the inflatable restraint steering wheel module coil. Refer to Inflatable Restraint Steering Wheel Module Coil Replacement .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.