Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2006SUBURBAN K2500, 6.0 UREPAIR AND DIAGNOSISENGINE MECHANICALSTARTERBATTERY, CHARGING SYSTEM AND STARTING SYSTEMREPAIR INSTRUCTIONSBATTERY TRAY REPLACEMENTINSTALLATION PROCEDURE

2006 Chevrolet Suburban K2500, 6.0 U

Installation Procedure

2006 Chevrolet Suburban K2500, 6.0 USECTION Installation Procedure

Fig 1: View Of Battery Tray Reinforcement & Bolts

GM847274

Courtesy of GENERAL MOTORS CORP.

Install the battery tray.
Install the bolts (2) to the battery tray reinforcement until snug.

Fig 2: View Of Battery Tray & Bolts At Fender Inner Panel

GM847278

Courtesy of GENERAL MOTORS CORP.

Install the bolts (1) to the fender inner panel until snug.

Fig 3: View Of Battery Tray & Bolts At Battery Tray Support

GM662962

Courtesy of GENERAL MOTORS CORP.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.