SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SUBURBAN K2500, 6.0 UREPAIR AND DIAGNOSISELECTRICALINSTRUMENT PANEL SYSTEM DISPLAYS, GAUGES AND CONSOLEREPAIR INSTRUCTIONSCONSOLE REPLACEMENT (W/CONSOLE MOUNTING BRACKET)INSTALLATION PROCEDURE
2006 Chevrolet Suburban K2500, 6.0 U

Installation Procedure

2006 Chevrolet Suburban K2500, 6.0 USECTION Installation Procedure
  1. Install the rear seat audio control to the console, if equipped. Refer to Audio Control Replacement - Rear Seat in Entertainment.
    2. Fig 1: Identifying Bolts Retaining Console To Instrument Panel
    GM854810Courtesy of GENERAL MOTORS CORP.
  2. Install the console in the vehicle.
  3. Connect the wire connectors.
  4. Move the console forward in order to install the retaining screws.
    5. NOTE: Refer to Fastener Notice in Cautions and Notices.
  5. Install the 2 screws (1).

    Tighten:  Tighten the screws to 4 N.m (35 lb in).

  6. Install the cupholder to the console. Refer to Cupholder Replacement (Non-Luxury)  or Cupholder Replacement (Luxury)  or Cupholder Replacement (Rear) .
  7. Install the upper console bezel. Refer to Bezel Replacement - Floor Console (Non-Luxury Upper)  or Bezel Replacement - Floor Console (Luxury Upper) .
  8. Install the radio amp fuse, if removed. Refer to Electrical Center Identification Views in Wiring Systems.
  9. Install both front seats. Refer to Seat Replacement - Front Bucket in Seats.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.