Removal Procedure

2006 Chevrolet Suburban K2500, 6.0 USECTION Removal Procedure
    Fig 1: Removing Side Front Door Trim Panel (With YE9 Late Production)
    GM1360281Courtesy of GENERAL MOTORS CORP.
  1. Remove the door handle bezel. Refer to Handle Bezel Replacement - InsideΒ .
  2. Remove the door trim panel upper extension. Refer to Trim Panel Replacement - Upper ExtensionΒ .
  3. Using a suitable flat-bladed tool, gently pry the manual lock lever from the door trim panel.
  4. Remove the push in fastener (3) at the front edge of the door trim.
  5. Remove the cap (5) covering the screw on the rear edge of the trim panel.
  6. Remove the trim panel screws.
    • Remove the screw (2) from within the opening where the manual door lock lever resides.
    • Remove the screw (4) from the opening in front of the armrest.
    • Remove the screw (6) from the rear edge of the trim panel.
  7. Carefully slide the trim panel (1) up in order to release the retainers from the door.
  8. Disconnect the electrical connectors.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.