Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SUBURBAN K2500, 6.0 UREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTMEMORY MODULESADJUSTABLE PEDAL SYSTEMREPAIR INSTRUCTIONSACCELERATOR PEDAL ASSEMBLY REPLACEMENTREMOVAL PROCEDURE
2006 Chevrolet Suburban K2500, 6.0 U
Removal Procedure
2006 Chevrolet Suburban K2500, 6.0 USECTION Removal Procedure
- Disconnect the adjustable pedals motor electrical connector.
- Remove the locking clip and disconnect the accelerator sensor connector.
- Remove the accelerator assembly. Refer to Accelerator Pedal with Position Sensor Replacement .
IMPORTANT:
Ensure that the brake pedal assembly is adjusted to its lowest position farthest from the drivers seat prior to removal of the accelerator assembly. Failure to do so could result in incorrect step-over height between the brake and accelerator pedals and improper function of the adjustable pedal system.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.