Installation Procedure

2006 Chevrolet Suburban K2500, 6.0 USECTION Installation Procedure
    Fig 1: Removing Cable Clips From A-Pillar & Cable From Radio
    GM798111Courtesy of GENERAL MOTORS CORP.
  1. Install the cable clips (1) to the A-pillar.
  2. Connect the electrical wire connector (4).
  3. Connect the cable (3) to the radio.
  4. Fig 2: Removing Cable From Radio Antenna Module & Cable Clips From Roof
    GM798113Courtesy of GENERAL MOTORS CORP.
  5. Install the cable clips (1) to the roof.
  6. Connect the cable (2) to the radio antenna module.
  7. Connect the wire connector to the radio antenna module.
  8. NOTE: Refer to Fastener Notice in Cautions and Notices.
  9. Install the bolt retaining the radio antenna module to the roof.

    Tighten:Β  Tighten the retaining bolt to 9 N.m (80 lb in).

  10. Install the headliner. Refer to Headliner Replacement in Interior Trim.
  11. Install the I/P trim panel. Refer to Trim Panel Replacement - Instrument Panel (I/P) Upper in Instrument Panel, Gages and Console.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.