Removal Procedure

2006 Chevrolet Suburban K2500, 6.0 USECTION Removal Procedure
IMPORTANT: Components of the DVD player cannot be serviced separately. Replace as an assembly.
    Fig 1: Locating DVD Player Front Retaining Bolts
    GM860211Courtesy of GENERAL MOTORS CORP.
  1. Move the screen to the open position.
  2. Remove the rear screw cover using a flat bladed tool.
  3. Remove the four retaining bolts (2).
  4. Insert the J 38778Β  between the headliner and the DVD player assembly. See Special ToolsΒ .
  5. With 1 hand holding the DVD player assembly, pry the retainer from the bracket.
  6. Fig 2: View Of DVD Player Assembly
    GM865248Courtesy of GENERAL MOTORS CORP.
  7. Allow the DVD player assembly to come to rest on the hook (1).
  8. Fig 3: Identifying DVD Player Wiring Harness & Connector
    GM865256Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.