Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SUBURBAN K2500, 6.0 UREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTCOMMUNICATION DEVICESPROGRAMMING AND SETUP - ALL SYSTEMSREPAIR INSTRUCTIONSBODY CONTROL MODULE PROGRAMMING AND SETUPBCM REPROGRAMMING
2006 Chevrolet Suburban K2500, 6.0 U
BCM Reprogramming
2006 Chevrolet Suburban K2500, 6.0 USECTION BCM Reprogramming
If the BCM is reprogrammed, the following procedures must be performed:
- BCM Reprogramming - Refer to Body Control Module (BCM) Programming/RPO Configuration in Computer/Integrating Systems.
- Theft Learn - Refer to Programming Theft Deterrent System Components in Theft Deterrent.
IMPORTANT:
This procedure has to be performed only for vehicles equipped with Passlock(tm) System.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.