Installation Procedure

2006 Chevrolet Suburban K1500, 5.3 ZSECTION Installation Procedure
WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Air Cleaner Assembly
    GM1602988Courtesy of GENERAL MOTORS CORP.
  1. Line up the retaining pins with the grommets.
  2. Install the air cleaner assembly until the air cleaner is seated fully on the mounts and is up against the fender apron.
  3. Fig 2: View Of Mass Airflow Sensor/Intake Air Temperature Sensor Electrical Connector
    GM1871110Courtesy of GENERAL MOTORS CORP.
  4. Install the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct ReplacementΒ .
  5. Connect the engine wiring harness electrical connector (1) to the MAF/IAT sensor.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.