SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SUBURBAN K1500, 5.3 ZREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1037 (POWER STEERING SYSTEM)REPAIR INSTRUCTIONSPOWER STEERING PUMP REPLACEMENT (4.3L)INSTALLATION PROCEDURE
2006 Chevrolet Suburban K1500, 5.3 Z

Installation Procedure

2006 Chevrolet Suburban K1500, 5.3 ZSECTION Installation Procedure
WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the power steering pump assembly in the vehicle with the power steering pump bracket.
    2. Fig 1: View Of Power Steering Pressure Hose & Power Steering Pump
    GM898604Courtesy of GENERAL MOTORS CORP.
  2. Install the power steering gear inlet hose (2) to the power steering pump assembly (1).

    Tighten:  Tighten the fitting to 32 N.m (24 lb ft).

    3. Fig 2: View Of Accessory Mounting Bracket
    GM188295Courtesy of GENERAL MOTORS CORP.
  3. Install the power steering pump bracket bolts and nut.

    Tighten:  Tighten the bolts and nut to 41 N.m (30 lb ft).

    4. Fig 3: Power Steering Pump & Mounting Bolts
    GM288829Courtesy of GENERAL MOTORS CORP.
  4. Install the power steering pump bolts.

    Tighten:  Tighten the bolts to 50 N.m (37 lb ft).

    5. Fig 4: View Of Power Steering Pump Rear Bracket Retaining Nuts
    GM288833Courtesy of GENERAL MOTORS CORP.
  5. Install the power steering pump rear bracket nuts.

    Tighten:  Tighten the nuts to 41 N.m (30 lb ft).

    6. Fig 5: View Of Power Steering Cooler Hose At Power Steering Pump
    GM395852Courtesy of GENERAL MOTORS CORP.
  6. Connect the power steering fluid cooler hose and the power steering fluid cooler hose clamp to the power steering pump assembly.
  7. Clean any excess power steering fluid from the vehicle and remove the drain pans.
  8. Connect the steering shaft coupling from the steering gear. Refer to Steering Shaft Coupling Replacement .
  9. Install the engine shield. Refer to Engine Shield Replacement .
  10. Install the power steering pump pulley. Refer to Power Steering Pump Pulley Replacement (6.6L)  or Power Steering Pump Pulley Replacement (4.3L, 4.8L, 5.3L, 6.0L, 6.2L) .
  11. Fill and bleed the power steering system. Refer to Power Steering System Bleeding .
  12. Program the power steering control module. Refer to Control Module References .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.