Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SUBURBAN K1500, 5.3 ZREPAIR AND DIAGNOSISBODY & FRAMESEATSSEAT SYSTEMREPAIR INSTRUCTIONSHEATED SEAT SWITCH REPLACEMENT - REARINSTALLATION PROCEDURE
2006 Chevrolet Suburban K1500, 5.3 Z
Installation Procedure
2006 Chevrolet Suburban K1500, 5.3 ZSECTION Installation Procedure
- Install the switch to the console panel.
- Install the retaining screw.
Tighten: Tighten the screws to 1.6 N.m (14 lb in).
- Connect the electrical connector.
- Install the center console end panel. Refer to Center Console End Panel Replacement in Instrument Panel, Gages, and Console.
NOTE:
Refer to Fastener Notice
in Cautions and Notices.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.