Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2006SUBURBAN C2500, 6.0 UREPAIR AND DIAGNOSISSTEERINGSTEERING LINKAGE (NON-RACK & PINION)REPAIR INSTRUCTIONSPITMAN ARM REPLACEMENTREMOVAL PROCEDURE

2006 Chevrolet Suburban C2500, 6.0 U

Removal Procedure

2006 Chevrolet Suburban C2500, 6.0 USECTION Removal Procedure

Fig 1: View Of Pitman Arm, Power Steering Gear, Washer & Nut

Courtesy of GENERAL MOTORS CORP.

Raise and suitable support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
Remove the power steering gear. Refer to Power Steering Gear Replacement in Power Steering System.
Install the power steering gear into a vise.
Remove the pitman arm nut and washer.

Fig 2: Remove The Pitman Arm From The Power Steering Gear (Non Rack and Pinion)

Courtesy of GENERAL MOTORS CORP.

Remove the pitman arm from the pitman shaft using J 6632-01 or J 29107-A .

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.