Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2006SUBURBAN C2500, 6.0 UREPAIR AND DIAGNOSISHEATING, VENTILATION & A/C (HVAC)HVAC CONTROL SYSTEMSHVAC SYSTEMS - AUTOMATICREPAIR INSTRUCTIONSBLOWER MOTOR CONTROL PROCESSOR REPLACEMENTREMOVAL PROCEDURE

2006 Chevrolet Suburban C2500, 6.0 U

Removal Procedure

2006 Chevrolet Suburban C2500, 6.0 USECTION Removal Procedure

Fig 1: View Of Electrical Connector At The Blower Motor

Courtesy of GENERAL MOTORS CORP.

If equipped, remove the sound insulator panel. Refer to Insulator Replacement - Instrument Panel (I/P) in Instrument Panel, Gages and Console.
Disconnect the electrical connector at the blower motor.

Fig 2: Blower Motor Control Processor

Courtesy of GENERAL MOTORS CORP.

Disconnect the electrical connector (4) from the blower motor control processor (2).
Remove the blower motor control processor retaining screws (3) from the HVAC module (1).
Remove the blower motor control processor (2) from the HVAC module (1).

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.