Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SUBURBAN C2500, 6.0 UREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 10 (ENGINE CONTROL SYSTEM - 8.1L - DTC P0030 TO DTC P0171)DTC P0118CONDITIONS FOR RUNNING THE DTC
2006 Chevrolet Suburban C2500, 6.0 U
Conditions for Running the DTC
2006 Chevrolet Suburban C2500, 6.0 USECTION Conditions for Running the DTC
WARNING: This page is about a different variant/trim than selected.
- The engine has been running for more than 60 seconds.
OR
The engine run time is less than 60 seconds when the intake air temperature (IAT) is more than 0°C (32°F)
- DTC P0118 runs continuously when the above condition is met.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.