Removal Procedure

2006 Chevrolet Suburban C2500, 6.0 USECTION Removal Procedure
WARNING: This page is about a different variant/trim than selected.
IMPORTANT: Clean all fuel and evaporative emission (EVAP) line connections and surrounding areas prior to disconnecting the lines in order to avoid possible fuel and/or EVAP system contamination.
    Fig 1: View Of Fuel Feed Line & Rear Fuel Feed Line
    GM1312082Courtesy of GENERAL MOTORS CORP.
  1. Remove the fuel tank. Refer to Fuel Tank Replacement (Front Tank)Β  or Fuel Tank Replacement (Rear Tank)Β .
  2. Disconnect and remove the fuel feed line (4) from the module and retaining clips. Refer to Quick Connect Fitting(s) Service (Plastic Collar)Β .
  3. Disconnect and remove the rear fuel feed line (2) from the module and retaining clips. Refer to Quick Connect Fitting(s) Service (Plastic Collar)Β .
  4. Cap the fuel feed and EVAP openings in order to prevent possible fuel/EVAP system contamination.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.