SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SUBURBAN C2500, 6.0 UREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 1 (ENGINE CONTROL SYSTEM - 8.1L - INTRODUCTION (2 OF 2))REPAIR INSTRUCTIONSFILLER TUBE REPLACEMENTREMOVAL PROCEDURE
2006 Chevrolet Suburban C2500, 6.0 U

Removal Procedure

2006 Chevrolet Suburban C2500, 6.0 USECTION Removal Procedure
WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Ground Wire & Fill Pipe Ground Strap
    GM1224385Courtesy of GENERAL MOTORS CORP.
  1. Remove the rear fuel tank. Refer to Fuel Tank Replacement (Front Tank)  or Fuel Tank Replacement (Rear Tank) .
  2. Remove the ground wire harness bolt.
  3. Reposition the ground wire and fill pipe ground strap.
    4. Fig 2: View Of Rear Axle Vent Hose & Clip
    GM1238176Courtesy of GENERAL MOTORS CORP.
  4. Open the rear axle vent hose clip at the fill pipe and remove the vent hose.
    5. Fig 3: View Of Fuel Fill Hose
    GM1224382Courtesy of GENERAL MOTORS CORP.
  5. Loosen the fuel tank fill hose clamp at the front tank.
  6. Disconnect the fuel fill hose vent line quick connect fitting from the tank. Refer to Quick Connect Fitting(s) Service (Plastic Collar) .
  7. Remove the fill hose from the front tank.
  8. Remove the fuel fill hose/pipe assembly.
  9. Cap the open end of the front fuel tank to prevent system contamination.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.