Scan Tool Output Controls

2006 Chevrolet Suburban C2500, 6.0 USECTION Scan Tool Output Controls
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Body Control Module

Scan Tool Output Control Additional Menu Selection(s) Description
Doors Rear Door Lock/Unlock The BCM actuates the door lock relay and liftgate lock when you select Lock. Rear doors and liftgate should lock. The BCM actuates the door unlock relay when you select Unlock. Rear doors and liftgate should unlock.
Doors Left Rear Window The BCM will control the left window up when you select Up. The BCM will control the left window down when you select Down.
Doors Right Rear Window The BCM will control the right window up when you select Up. The BCM will control the right window down when you select Down.
Driver Door Switch and Passenger Door Switch

Scan Tool Output Control Additional Menu Selection(s) Description
Output Control Window Up/Down The DDS or PDS will command the window up and down
Output Control Door Lock/Unlock Test The DDS or PDS will command the door lock actuator to lock or unlock
Output Control Mirror Left/Right The DDS or PDS will command the mirror left and right
Output Control Mirror Up/Down The DDS or PDS will command the mirror up and down
Output Control Mirror Heat The DDS or PDS will command the mirror heater on and off
Output Control Passenger Window Lockout Indicator The DDS will command the window lockout indicator on when you select ON and turn it off when you select OFF
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.