Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SUBURBAN C2500, 6.0 UREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 911 (HVAC SYSTEM - MANUAL)
2006 Chevrolet Suburban C2500, 6.0 U
Section 911 (HVAC System - Manual)
2006 Chevrolet Suburban C2500, 6.0 USECTION Section 911 (HVAC System - Manual)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
- Specifications
- Schematic and Routing Diagrams
- Component Locator
- Diagnostic Information and Procedures
- Diagnostic Code Index
- Scan Tool Output Controls
- Scan Tool Data List
- Scan Tool Data Definitions
- DTC B0413, B0423, B0433, B3779 or B3782
- DTC P0532 or P0533
- DTC P0645
- Symptoms - HVAC Systems - Manual
- HVAC Compressor Clutch Does Not Engage
- HVAC Compressor Clutch Does Not Disengage
- Blower Motor Always On
- Blower Motor Inoperative
- Blower Motor Malfunction
- Auxiliary Blower Motor Malfunction
- Too Hot in Vehicle
- Too Cold in Vehicle
- Air Delivery Improper
- Air Recirculation Malfunction
- Re-Calibrating Actuators
- Repair Instructions
- HVAC Control Module Replacement
- Air Temperature Actuator Replacement - Right
- Air Temperature Actuator Replacement - Left
- Mode Actuator Replacement
- Recirculation Actuator Replacement
- HVAC Control Assembly Replacement - Front Auxiliary
- HVAC Control Assembly Replacement - Rear Auxiliary
- HVAC Control Module Replacement - Auxiliary
- Air Temperature Actuator Replacement - Auxiliary (Delphi)
- Mode Actuator Replacement - Auxiliary (Delphi)
- Description and Operation
- Special Tools and Equipment
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.