Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2006SUBURBAN C2500, 6.0 UREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 697 (WIPER SYSTEM & WASHER SYSTEM)REPAIR INSTRUCTIONSWIPER MOTOR COVER REPLACEMENTINSTALLATION PROCEDURE

2006 Chevrolet Suburban C2500, 6.0 U

Installation Procedure

2006 Chevrolet Suburban C2500, 6.0 USECTION Installation Procedure

WARNING: This page is about a different car, the 2006 GMC Sierra and 2006 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Position the cover (4) to the wiper motor.

NOTE: Refer to Fastener Notice .

Install the 4 screws (3) to the cover.
Tighten: Tighten the 4 screws equally to 2.6 N.m (23 lb in).
Connect the electrical connector (2) and install the CPA.

Fig 1: Reinstalling Electrical Connector To Wiper Motor
Courtesy of GENERAL MOTORS CORP.
Install the air inlet panel. Refer to Air Inlet Grille Panel Replacement .
Install the wiper arms. Refer to Wiper Arm Replacement .
Install the radio antenna. Refer to Fixed Antenna Replacement .
Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure (Single Battery) or Battery Negative Cable Disconnect/Connect Procedure (Auxiliary Battery) .
Close the hood.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.