Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Scan Tool Data Definitions
- Battery Voltage
-
The scan tool displays 0.0-16.0 volts. The battery voltage input represents the system voltage measured at the BCM ignition feed input.
- (Driver/Passenger) Door Ajar Switch (w/o DDM or w/o PDM))
-
Input from the respecting door indicating door status.
- Ignition Accessory
-
Input from ignition switch Accessory circuit. Used to determine power mode. Hot in ACC and ON.
- Ignition 0
-
Input to the control module from the ignition switch indicating the Ignition 0 position. Switch closed (HOT) in ignition switch positions UNLOCK, ACC, ON, and START
- Ignition 1
-
Input to the control module from the ignition switch indicating the Ignition 1 position. Switch closed (HOT) in ignition switch positions ON and START.
- Key in Ignition
-
Input from ignition switch indicating that the ignition key is inserted into the ignition switch. HOT with key in ignition switch.
- Julian Date of Build
-
The day of the year when module was built.
- Left Rear/Rear Cargo Door Ajar Switch
-
Input from the left rear/rear cargo door showing the state of it.
- Right Rear Door Ajar Sw.
-
Input from the right rear door showing the state of it.
- SWC Switch Power
-
Indicates the state of the supply voltage to the steering wheel controls supply voltage.
- SWC Switch Voltage
-
Indicates the steering wheel controls supply voltage.
- Year Module Built
-
The year when module was built.
- 8 Digit GM Part Number
-
The module's part number.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.