SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SUBURBAN C2500, 6.0 UREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 547 (ENTERTAINMENT SYSTEM)REPAIR INSTRUCTIONSCOAXIAL CABLE REPLACEMENTINSTALLATION PROCEDURE
2006 Chevrolet Suburban C2500, 6.0 U

Installation Procedure

2006 Chevrolet Suburban C2500, 6.0 USECTION Installation Procedure
WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Radio Control Coaxial Cable At IP Wiring Harness
    GM65101Courtesy of GENERAL MOTORS CORP.
  1. Install the radio control coaxial cable into position in the vehicle.
  2. Tape the radio control coaxial cable to the IP wiring harness along the IP lower support beam.
  3. Connect the radio control coaxial cable to the radio control.
    4. Fig 2: Radio Control To Bracket Alignment
    GM65092Courtesy of GENERAL MOTORS CORP.
  4. Align the radio control locator tab to the IP center support bracket locator hole.
  5. Install the radio control.
    6. Fig 3: Radio Control & Center Bracket
    GM65091Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.