SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SUBURBAN C2500, 6.0 UREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 543 (LIGHTING SYSTEMS)REPAIR INSTRUCTIONSLICENSE LAMP REPLACEMENTINSTALLATION PROCEDURE
2006 Chevrolet Suburban C2500, 6.0 U

Installation Procedure

2006 Chevrolet Suburban C2500, 6.0 USECTION Installation Procedure
WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: License Lamp Assembly To Tail Lamp Opening
    GM64660Courtesy of GENERAL MOTORS CORP.
  1. Install the license lamp assembly through the tail lamp opening.
  2. Position the lamp assembly and hold in place.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the screws securing the lamp assembly to the rear fascia.

    Tighten:  Tighten the license lamp assembly retaining screws to 2 N.m (18 lb in).

    4. Fig 2: Tail Lamp Opening At License Lamp Assembly & Sockets
    GM64661Courtesy of GENERAL MOTORS CORP.
  4. Install the socket to the license lamp assembly.

    Rotate the socket clockwise to engage the locking tabs.

  5. Install the inner tail lamp. Refer to Tail Lamp Replacement .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.