Installation Procedure

2006 Chevrolet Suburban C2500, 6.0 USECTION Installation Procedure
WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the antenna dual cable strap to the vehicle.
  2. Beginning from the right side, align and secure the antenna dual cable strap retaining clips to the rear compartment flange.
  3. Install the right rear wheelhouse filler panel. Refer to WHEELHOUSE PANEL REPLACEMENT in Body Rear End.
  4. Install the right rear tire and wheel assembly. Refer to TIRE AND WHEEL REMOVAL AND INSTALLATION in Tires and Wheels.
  5. Lower the vehicle.
    Fig 1: Installing Antenna Dual Cable Strap To Vehicle
    G01453642Courtesy of GENERAL MOTORS CORP.
  6. Install the antenna short braided ground strap (2), then the antenna dual cable strap (1) to the rear fascia retaining stud.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.