Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2006SUBURBAN C2500, 6.0 UREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 512 (LIGHTING SYSTEMS)REPAIR INSTRUCTIONSHAZARD WARNING SWITCH REPLACEMENTINSTALLATION PROCEDURE

2006 Chevrolet Suburban C2500, 6.0 U

Installation Procedure

2006 Chevrolet Suburban C2500, 6.0 USECTION Installation Procedure

WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

Install the hazard warning switch to the center air outlet.
Align the switch to the rear of the air outlet, then push to secure the switch.
Install the center air outlet and the air distribution duct to the IP upper trim pad. Refer to AIR OUTLET REPLACEMENT - CENTER in Heating, Ventilation and Air Conditioning.

Fig 1: Installing Hazard Warning Switch To Center Air Outlet
Courtesy of GENERAL MOTORS CORP.
Install the hazard warning switch button.
Align the button to the switch, then push to secure.
Position the switch in the off position.
Install the IP upper trim pad. Refer to TRIM PAD REPLACEMENT - INSTRUMENT PANEL (I/P) UPPER in Instrument Panel, Gauges and Console.

Fig 2: Hazard Warning Switch Button
Courtesy of GENERAL MOTORS CORP.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.