Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SUBURBAN C2500, 6.0 UREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 358 (LIGHTING SYSTEMS)REPAIR INSTRUCTIONSTAIL/TURN SIGNAL LAMP REPLACEMENT (EXCEPT STEPSIDE)REMOVAL PROCEDURE
2006 Chevrolet Suburban C2500, 6.0 U
Removal Procedure
2006 Chevrolet Suburban C2500, 6.0 USECTION Removal Procedure
WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Ensure that the headlamp switch is in the OFF position.
- Lower the end gate.
- Remove the 2 screws retaining the tail/turn signal lamp assembly to the body.
- Identify the bulb in need of replacement.
- The top bulb is a parking lamp and stop lamp
- The center bulb is a turn indicator lamp
- The lower bulb is a backup lamp
- Turn the socket assembly.
- Remove the socket assembly from the housing.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.