Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Scan Tool Data Definitions (Gen 5)
- 8 Digit GM Part Number
-
This displays the part number for the vehicle communication interface module (VCIM).
- Component Serial Number 13-16
-
This is the third partition of the serial number.
- Electronic Serial Number
-
This is the electronic serial number stored in the VCIM which is used by the OnStar® Call Center.
- Julian Date of Build
-
This displays the day of the year the module was built.
- Module I.D.
-
This displays the version of OnStar® which the vehicle is equipped with.
- Software I.D.
-
This displays the 3-digit number of the software version used on the OnStar VCIM.
- VCI Module Station I.D.
-
This is the station identification number stored in the VCIM which is used by the OnStar® Call Center.
- Year Module Build
-
This displays the year the module was built.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.