SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SUBURBAN C2500, 6.0 UREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 260 (BODY FRONT END)REPAIR INSTRUCTIONSHOOD REPLACEMENTINSTALLATION PROCEDURE
2006 Chevrolet Suburban C2500, 6.0 U

Installation Procedure

2006 Chevrolet Suburban C2500, 6.0 USECTION Installation Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2003 GMC Savana Special, 2003 GMC Savana Camper Special, 2003 GMC Savana, 2003 Chevrolet RV Cutaway, and 2003 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. With an assistant, install the hood to the vehicle.
    CAUTION: Refer to FASTENER NOTICE .
  2. Install the hinge pivot bolt (4) and nuts (2) to the hinge (1).

    Tighten 

    Tighten the hood hinge pivot bolts and nuts to 25 N.m (18 lb ft).

  3. Install the underhood lamp and the harness to the hood. Refer to UNDERHOOD LAMP REPLACEMENT .
  4. Install air inlet grille panels. Refer to Air Inlet Grille Panel Replacement .
  5. Install the wiper arms to the vehicle. Refer to WIPER ARM REPLACEMENT .
    Fig 1: Installing Hinge Pivot Bolt & Nuts To Hinge
    G02422922Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.