SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SUBURBAN C2500, 6.0 UREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 243 (CELLULAR COMMUNICATION SYSTEM)REPAIR INSTRUCTIONSONSTAR MICROPHONE REPLACEMENTINSTALLATION PROCEDURE
2006 Chevrolet Suburban C2500, 6.0 U

Installation Procedure

2006 Chevrolet Suburban C2500, 6.0 USECTION Installation Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2003 GMC Savana Special, 2003 GMC Savana Camper Special, 2003 GMC Savana, 2003 Chevrolet RV Cutaway, and 2003 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Feed the microphone (1) wire through the hole in the headliner.
  2. Align the microphone (1) with the hole in the headliner and install the microphone in the opening.
    Fig 1: Installing Microphone
    G02422537Courtesy of GENERAL MOTORS CORP.
  3. Rotate the microphone (1) counter clockwise to secure.
  4. Glue or tape the microphone wiring to the headliner.
    Fig 2: Rotating Microphone Counterclockwise
    G02422538Courtesy of GENERAL MOTORS CORP.
  5. Install the front headliner. Refer to HEADLINER REPLACEMENT - FRONT .
  6. Connect the microphone electrical connector (1).
  7. Install the passenger windshield garnish molding. Refer to WINDSHIELD GARNISH MOLDING REPLACEMENT .
    Fig 3: Connecting Microphone Electrical Connector
    G02422539Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.