SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SUBURBAN C2500, 6.0 UREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 2157 (WIRING SYSTEMS AND POWER MANAGEMENT - COMPONENT CONNECTOR END VIEWS PART 3)OUTSIDE REARVIEW MIRROR - DRIVER (DL8/DPN)
2006 Chevrolet Suburban C2500, 6.0 U

Outside Rearview Mirror - Driver (DL8/DPN)

2006 Chevrolet Suburban C2500, 6.0 USECTION Outside Rearview Mirror - Driver (DL8/DPN)
WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Outside Rearview Mirror - Driver (DL8/DPN) Connector End View
GM1866826Courtesy of GENERAL MOTORS CORP.
Outside Rearview Mirror - Driver (DL8/DPN)

Pin Wire Circuit Function
1 0.5 L-GN 89 Driver Mirror Motor Down Control (DL8/DPN)
2 0.5 WH 81 Driver Mirror Motor Right Control (DL8/DPN)
3 0.5 BK 1850 Ground (DL8/DPN)
4 - - Not Used
5 0.5 L-BU/WH 1314 Left Front Turn Signal Lamp Supply Voltage (DL3/DPN)
6 0.5 TN 329 Driver Mirror Motor Supply Voltage (DL8/DPN)
7 0.5 OG 2267 Mirror Heating Element Supply Voltage (DL8/DPN)
8-9 - - Not Used
10 0.5 BK 1850 Ground (DL3/DPN)
Connector Part Information 
  • OEM: 13548147
  • Service: See Catalog
  • Description: 10-Way M (BK)
Terminal Part Information 
  • Pins: 1-7, 10
  • Terminal/Tray: SAITW-A03T-064/20
  • Core/Insulation Crimp: J/J
  • Release Tool/Test Probe: J-38125-215A/J-35616-65B (L-BU)
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.