Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SUBURBAN C2500, 6.0 UREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 208 (STARTING SYSTEM)REPAIR INSTRUCTIONSSTARTER MOTOR REPLACEMENT (4.3L)INSTALLATION
2006 Chevrolet Suburban C2500, 6.0 U
Starter Motor Replacement (4.3L): Installation
2006 Chevrolet Suburban C2500, 6.0 USECTION Installation
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2003 GMC Savana Special, 2003 GMC Savana Camper Special, 2003 GMC Savana, 2003 Chevrolet RV Cutaway, and 2003 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
- Install the starter motor to the engine. See Figure. Install the bolts and the shims, if present, to the starter motor. Tighten the bolts to specification. See FASTENER TIGHTENING SPECIFICATIONS .
- Connect the wires to the starter solenoid. See Figure. Tighten the starter lead nut to the solenoid to specification. Tighten the starter solenoid wires to the solenoid to specification. See FASTENER TIGHTENING SPECIFICATIONS .
- Install the starter motor brackets and shields. See Figure.
- Connect the battery negative cable. Tighten to specification. See FASTENER TIGHTENING SPECIFICATIONS .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.