SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SUBURBAN C2500, 6.0 UREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 2002 (WIRING SYSTEMS AND POWER MANAGEMENT - COMPONENT CONNECTOR END VIEWS - A/C COMPRESSOR THROUGH ELECTRONIC POWER STEERING MODULE X1)COMPONENT CONNECTOR END VIEWSDOOR LATCH - PASSENGER
2006 Chevrolet Suburban C2500, 6.0 U

Door Latch - Passenger

2006 Chevrolet Suburban C2500, 6.0 USECTION Door Latch - Passenger
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Door Latch - Passenger Connector End View
GM812596Courtesy of GENERAL MOTORS CORP.
Door Latch - Passenger

Pin Wire Circuit Function
1 0.35 TN/WH 746 Right Front Door Ajar Switch Signal
2 - - Not Used
3 0.35 YE 5943 Low Reference
4 - - Not Used
5 0.5 GY/BK 1663 Passenger Door Lock Actuator Unlock Control
6 0.5 TN 5946 Passenger Door Lock Motor Common
Connector Part Information
  • Harness Type: Passenger Door
  • OEM Connector: 10768369
  • Service Connector: 88986251
  • Description: 6-Way F 1.2 Timer Series (BK)
Terminal Part Information
  • Terminated Lead: Service by Connector Assembly - 88986251
  • Release Tool: J-38125-560
  • Diagnostic Test Probe: J-35616-14 (GN)
  • Terminal/Tray: Pins 1, 3 - 4-969005-1/16
  • Terminal/Tray: Pins 5, 6 - 964274-2/16
  • Core/Insulation Crimp: E/1
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.