SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SUBURBAN C2500, 6.0 UREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 2002 (WIRING SYSTEMS AND POWER MANAGEMENT - COMPONENT CONNECTOR END VIEWS - A/C COMPRESSOR THROUGH ELECTRONIC POWER STEERING MODULE X1)COMPONENT CONNECTOR END VIEWSACCESSORY AC/DC POWER CONTROL MODULE X1 (HP2)
2006 Chevrolet Suburban C2500, 6.0 U

Accessory AC/DC Power Control Module X1 (HP2)

2006 Chevrolet Suburban C2500, 6.0 USECTION Accessory AC/DC Power Control Module X1 (HP2)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Accessory AC/DC Power Control Module X1 (HP2) Connector End View
GM1540770Courtesy of GENERAL MOTORS CORP.
Accessory AC/DC Power Control Module X1 (HP2)

Pin Wire Circuit Function
1 - - Not Used
2 0.8 WH 6807 Plug Switch Signal
3 - - Not Used
4 0.8 BK 5683 110 VAC +
5 - - Not Used
6 0.8 D-BU 5685 110 VAC -
Connector Part Information
  • Harness Type: AC Outlet Jumper
  • OEM Connector: 6098-4542
  • Service Connector: 19153185
  • Description: 6-Way F 2.8 Series (OG)
Terminal Part Information
  • Terminal/Tray: Service by Harness - See Part Catalog
  • Core/Insulation Crimp: Not Available
  • Release Tool/Test Probe: Not Available
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.