Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SUBURBAN C2500, 6.0 UREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1942 (HYBRID/EV CONTROL SYSTEM)DIAGNOSTIC INFORMATION AND PROCEDURESDTC P0C2BCIRCUIT/SYSTEM VERIFICATION
2006 Chevrolet Suburban C2500, 6.0 U
Circuit/System Verification
2006 Chevrolet Suburban C2500, 6.0 USECTION Circuit/System Verification
WARNING: This page is about a different car, the 2011 GMC Yukon, 2011 Chevrolet Tahoe, and 2011 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.
- Verify that DTC B1433 is not set.
- If the DTC is set, refer to DTC B1433 .
- Ignition ON, engine OFF, command the Aux. Trans. Pump Speed to 50 percent with the scan tool, maintain pump operation for at least 60 seconds while observing the hybrid powertrain control module aux. trans. fluid pump actual and the aux. trans. fluid pump commanded parameter. The actual parameter should remain within 10 percent of commanded value during the 60 second test.
- If not within the specified range, refer to Circuit System Testing.
- While commanding the aux. trans. fluid pump speed to 50 percent observe and record the hybrid powertrain control module Aux. Trans. Fluid Pump Fault Status 1 and the hybrid powertrain control module Aux. Trans. Fluid Pump Fault Status 2 parameters. Both readings should display No Fault.
- If the reading displays No PWM Response, refer to Circuit System Testing.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.