Module Replacement - Seat Climate Control - Front Seat

2006 Chevrolet Suburban C2500, 6.0 USECTION Module Replacement - Seat Climate Control - Front Seat
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Front Seat Heater Control Module & Components
GM1678396Courtesy of GENERAL MOTORS CORP.
Module Replacement - Seat Climate Control - Front Seat

Callout Component Name
Preliminary Procedure 
Remove the front passenger seat. Refer to Front Seat Replacement - Bucket (without HP2) , Front Seat Replacement - Bucket (with HP2) .
1 Passenger Seat Adjuster Outer Finish Cover
Refer to Front Seat Cushion Outer Trim Panel Replacement (with HP2) , Front Seat Cushion Outer Trim Panel Replacement (Manual Seat without HP2) , Front Seat Cushion Outer Trim Panel Replacement (Power Seat without HP2) .
2 Passenger Seat Adjuster Inner Finish Cover
Refer to Front Seat Cushion Inner Trim Panel Replacement (without HP2) , Front Seat Cushion Inner Trim Panel Replacement (with HP2) .
3 Passenger Seat Riser Finish Cover
TIP:  Pull rearward to disengage the cover from the seat riser.
4 Passenger Seat Cushion Cover and Pad
Refer to Seat Cushion Trim Cover and Pad Replacement (without HP2) , Seat Cushion Trim Cover and Pad Replacement (with HP2) .
5 Front Seat Climate Control Module Bolt (Qty: 4)
CAUTION:

Refer to Fastener Caution .


Tighten 
9 N.m (80 lb in)
6 Front Seat Climate Control Module
TIP:  Disconnect the electrical connector.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.