Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SUBURBAN C2500, 6.0 UREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1913 (POWER DOOR LOCK SYSTEM AND RELEASE SYSTEMS)DIAGNOSTIC INFORMATION AND PROCEDURESDTC B153ACIRCUIT/SYSTEM VERIFICATION
2006 Chevrolet Suburban C2500, 6.0 U
Circuit/System Verification
2006 Chevrolet Suburban C2500, 6.0 USECTION Circuit/System Verification
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
- With the liftgate closed, observe the scan tool Liftgate Latch Pawl, Ratchet, and Sector Switch parameters. Each parameter status should be as listed below:
- LGM Latch Pawl Sw parameter - Inactive
- LGM Latch Ratchet Sw. parameter - Inactive
- Liftgate Latch Sector Switch parameter - Inactive
- With the liftgate open, observe the scan tool Liftgate Latch Pawl, Ratchet, and Sector Switch parameters. Each parameter status should be as listed below:
- LGM Latch Pawl Sw parameter - Active
- LGM Latch Ratchet Sw. parameter - Active
- LGM Latch Sector Sw. parameter - Inactive
- Sector Switch Test - Close the liftgate allowing the cinch motor to pull the liftgate closed. Observing the scan tool LGM Latch Sector Sw. parameter while the liftgate is being automatically cinched closed; the parameter should change from Inactive to Active then back to Inactive within 10 seconds.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.