SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SUBURBAN C2500, 6.0 UREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1890 (WIPER SYSTEM AND WASHER SYSTEM)REPAIR INSTRUCTIONSWINDSHIELD WIPER AND WASHER SWITCH REPLACEMENT
2006 Chevrolet Suburban C2500, 6.0 U

Windshield Wiper and Washer Switch Replacement

2006 Chevrolet Suburban C2500, 6.0 USECTION Windshield Wiper and Washer Switch Replacement
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Windshield Wiper and Washer Switch
GM1701070Courtesy of GENERAL MOTORS CORP.
Windshield Wiper and Washer Switch Replacement

Callout Component Name
WARNING:

Refer to SIR Warning .

Preliminary Procedure

  1. Remove the steering wheel. Refer to Steering Wheel Replacement .
  2. Remove the steering column shroud. Refer to Steering Column Shroud Replacement (With Electronic Tilt Steering) , Steering Column Shroud Replacement (Without Electronic Tilt Steering) .
1 Multifunction Turn Signal Switch Screw (Qty: 2)
CAUTION:

Refer to Fastener Caution .


Tighten 
3 N.m (27 lb in)
2 Multifunction Turn Signal Switch
  1. The wipers/washer switch is integral to the multifunction turn signal switch.
  2. Disconnect the electrical connectors as needed.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.