SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SUBURBAN C2500, 6.0 UREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1890 (WIPER SYSTEM AND WASHER SYSTEM)REPAIR INSTRUCTIONSWINDSHIELD WASHER SOLVENT CONTAINER REPLACEMENTINSTALLATION PROCEDURE
2006 Chevrolet Suburban C2500, 6.0 U

Installation Procedure

2006 Chevrolet Suburban C2500, 6.0 USECTION Installation Procedure
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Washer Solvent Container
    GM1669972Courtesy of GENERAL MOTORS CORP.
  1. Transfer washer pumps and level indicator to the new washer solvent container (2).
    2. Fig 2: Windshield Washer Solvent Container
    GM1733024Courtesy of GENERAL MOTORS CORP.
  2. Install the windshield washer container assembly (2).
  3. Install the upper windshield washer container bolt to the auxiliary battery tray, if equipped.
    4. CAUTION:

    Refer to Fastener Caution .

  4. Install the upper windshield washer solvent container bolts and tighten to 9 N.m (80 lb in).
  5. Install the auxiliary battery tray, if equipped. Refer to Auxiliary Battery Tray Replacement .
  6. Install the battery tray, if working on a HYBRID (HP2). Refer to Battery Tray Replacement .
  7. Install the windshield washer solvent cap.
  8. Connect the electrical connectors.
    9. Fig 3: Washer Pump Hoses
    GM1733021Courtesy of GENERAL MOTORS CORP.
  9. Connect the washer pump hoses (1, 2). Refer to Windshield Washer Hose Replacement .
  10. Install the left front wheelhouse liner. Refer to Front Wheelhouse Liner Replacement - Left Side .
  11. Install the left front wheel assembly. Refer to Tire and Wheel Removal and Installation .
  12. Fill the washer solvent container with windshield solvent. Refer to Fluid and Lubricant Recommendations .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.