Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SUBURBAN C2500, 6.0 UREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1773 (ENGINE CONTROL SYSTEM & FUEL SYSTEM - 4.3L - DTC P0340 TO DTC P2544)DTC P0446CIRCUIT/SYSTEM VERIFICATION
2006 Chevrolet Suburban C2500, 6.0 U
Circuit/System Verification
2006 Chevrolet Suburban C2500, 6.0 USECTION Circuit/System Verification
WARNING: This page is about a different car, the 2010 GMC Sierra and 2010 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition ON and fuel cap removed, verify that the Fuel Tank Pressure Sensor parameter is between 1.3-1.7 volts.
- If not within the specified range, go to the fuel tank pressure sensor section in Circuit/System Testing.
- Install the fuel cap.
- With the engine running, the EVAP canister vent solenoid valve open, use a scan tool to command the EVAP canister purge solenoid valve to 100 percent. The fuel tank vacuum should not increase to more than -15 mmHg (-8 inches H2O).
- If the fuel tank vacuum is greater than the specified range, go to the restriction section in Circuit/System Testing.
- Using the scan tool, decrease the canister purge duty cycle from 100 percent to 0 percent. The vacuum should decrease to near zero.
- If the fuel tank vacuum does not return to zero or appears to decrease too slowly go to the restriction section in Circuit/System Testing.
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.