Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Circuit/System Description
The bed sensor is a component of the content theft deterrent (CTD) system which monitors the status of the tailgate. The body control module (BCM) applies B+ to the bed sensor signal circuit. The bed sensor is a switch that opens and closes based on the position of the tailgate. With the switch closed, the signal circuit is switched to ground, indicating the tailgate has been opened. If the content theft deterrent (CTD) system is armed and the BCM sees the tailgate open, the CTD alarm will be activated.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.