SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SUBURBAN C2500, 6.0 UREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1703 (ADJUSTABLE PEDAL SYSTEM)REPAIR INSTRUCTIONSBRAKE PEDAL ASSEMBLY REPLACEMENTREMOVAL PROCEDURE
2006 Chevrolet Suburban C2500, 6.0 U

Removal Procedure

2006 Chevrolet Suburban C2500, 6.0 USECTION Removal Procedure
WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the steering column from the vehicle. Refer to Steering Column Replacement (Without HP2) or Steering Column Replacement (HP2) .
  2. Disconnect the electrical connectors from the following components:
    • Adjustable pedal motor assembly
    • Memory sensor connector, if equipped
    • Brake pedal position sensor
    • Stoplamp switch
    3. Fig 1: View Of Accelerator Pedal Position Sensor Assembly
    GM1704147Courtesy of GENERAL MOTORS CORP.
  3. Remove the accelerator pedal position sensor assembly. Refer to Accelerator Pedal Position Sensor Replacement .
  4. Remove the left side floor air outlet duct. Refer to Floor Air Outlet Duct Replacement - Left Side .
    5. Fig 2: Locating Brake Booster Pushrod Retainer Bolt
    GM1892143Courtesy of GENERAL MOTORS CORP.
  5. Remove the brake booster pushrod retainer bolt (1).
    6. Fig 3: Locating Brake Booster Pushrod Retainer
    GM1892145Courtesy of GENERAL MOTORS CORP.
  6. Remove the brake booster pushrod retainer (1).
    7. Fig 4: View Of Stoplamp Switch
    GM1892146Courtesy of GENERAL MOTORS CORP.
  7. Remove the stoplamp switch (1).
  8. Disconnect the brake booster pushrod from the brake pedal pivot.
    9. Fig 5: Locating Adjustable Pedal Bracket Nuts
    GM1892147Courtesy of GENERAL MOTORS CORP.
  9. Remove the adjustable pedal bracket nuts (1).
    10. Fig 6: View Of Adjustable Pedal Bracket Bolt
    GM1892149Courtesy of GENERAL MOTORS CORP.
  10. Remove the adjustable pedal bracket bolt (1).
  11. Position the brake booster forward until the studs are past the adjustable pedal bracket holes and support with heavy mechanics wire or equivalent.
  12. Disconnect and position aside any wiring harnesses as necessary.
  13. Remove the adjustable pedal assembly from the vehicle.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.