Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SUBURBAN C2500, 6.0 UREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1689 (DATA COMMUNICATION SYSTEM)DIAGNOSTIC INFORMATION AND PROCEDURESDTC U189ACIRCUIT/SYSTEM TESTING
2006 Chevrolet Suburban C2500, 6.0 U
Circuit/System Testing
2006 Chevrolet Suburban C2500, 6.0 USECTION Circuit/System Testing
WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition OFF, disconnect harness connector X1 of the APM.
- Test for less than 0.5 volts between the wake up signal circuit terminal 3 and ground.
- If greater than the specified range, test the signal circuit for a short to voltage. If the circuit tests normal, replace the SDGM.
- Disconnect harness connector X1 of the PIM.
- Test for B+ between the wake up signal circuit terminal 19 and ground.
- If less than the specified value, test the circuit for an open/high resistance. If the circuit tests normal, replace the SDGM.
- Test for less than 1.0 ohm between the APM and the PIM on the following circuit terminals.
- PTLAN + APM terminal 2 and PIM terminal 25
- PTLAN - APM terminal 1 and PIM terminal 24
- If greater than the specified range, test the circuit for an open/high resistance.
- Ignition OFF, disconnect harness connector X3 of the engine control module (ECM).
- Test for less than 1.0 ohm between the APM and the ECM on the following circuit terminals.
- PTLAN + APM terminal 11 and ECM terminal 53
- PTLAN - APM terminal 10 and ECM terminal 33
- If greater than the specified range, test the circuit for an open/high resistance.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.