SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SUBURBAN C2500, 6.0 UREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1686 (HVAC SYSTEM - MANUAL)REPAIR INSTRUCTIONSAIR CONDITIONING REFRIGERANT TEMPERATURE SENSOR REPLACEMENT
2006 Chevrolet Suburban C2500, 6.0 U

Air Conditioning Refrigerant Temperature Sensor Replacement

2006 Chevrolet Suburban C2500, 6.0 USECTION Air Conditioning Refrigerant Temperature Sensor Replacement
WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Air Conditioning Refrigerant Temperature Sensor
GM2359758Courtesy of GENERAL MOTORS CORP.
Callout Component Name

Preliminary Procedures

  1. Remove the air conditioning evaporator core. Refer to Air Conditioning Evaporator Core Replacement (Without HP2) or Air Conditioning Evaporator Core Replacement (With HP2) .
  2. Reposition any wiring or hoses to gain access to evaporator temperature sensor.
1 Air Conditioning Evaporator Air Temperature Sensor

Procedure

  1. Disconnect the wiring connector
  2. Remove Air Conditioning Evaporator Air Temperature Sensor
  3. Ensure that the evaporator air temperature sensor is installed in the exact same position as the previously removed evaporator core.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.