SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SUBURBAN C2500, 6.0 UREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1681 (LIGHTING SYSTEM)REPAIR INSTRUCTIONSFRONT FOG LAMP REPLACEMENT (GMC)
2006 Chevrolet Suburban C2500, 6.0 U

Front Fog Lamp Replacement (GMC)

2006 Chevrolet Suburban C2500, 6.0 USECTION Front Fog Lamp Replacement (GMC)
WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Front Fog Lamp (GMC)
GM1839457Courtesy of GENERAL MOTORS CORP.
Callout Component Name

Preliminary Procedures

  1. Remove either the LF or RF wheelhouse liners. Refer to Front Wheelhouse Liner Replacement - Left Side (Chevrolet) or Front Wheelhouse Liner Replacement - Left Side (GMC) for the LF or Front Wheelhouse Liner Replacement - Right Side (Chevrolet) or Front Wheelhouse Liner Replacement - Right Side (GMC) for the RF wheelhouse liner.
  2. Disconnect the electrical connector.
  3. From inside the front air deflector, using a six point 10 mm socket or the open end of a 3/8" extension, compress the retainers and push outward on the two upper mounting studs on the fog lamp.
  4. Using the same tools, compress the lower retainer and push outward on the adjustment screw for the fog lamp.
  5. Remove the fog lamp assembly.
1 Fog Lamp Assembly
WARNING: Refer to Halogen Bulb Warning .

Tip:  Transfer the bulb assembly as needed.
2 Fog Lamp Retainers (Qty: 3)

Procedure

  1. Install the retainers back onto the fog lamp upper mounting studs.
  2. Install the retainer onto the fog lamp adjusting screw.
  3. Firmly push the lamp assembly back into the front air deflector until all three retainers are engaged to the air deflector.
  4. Aim the fog lamps after the fog lamp has been replaced. Refer to Fog Lamp Aiming .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.