Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SUBURBAN C2500, 6.0 UREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1671 (OBJECT DETECTION SYSTEM)DIAGNOSTIC INFORMATION AND PROCEDURESREAR VISION CAMERA SYSTEM MALFUNCTION (UVC WITH NAVIGATIONAL RADIO)CIRCUIT/SYSTEM VERIFICATION
2006 Chevrolet Suburban C2500, 6.0 U
Circuit/System Verification
2006 Chevrolet Suburban C2500, 6.0 USECTION Circuit/System Verification
WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Inspect the rearview camera and verify there is no debris on the lens and that the bezel or bezel seal is not damaged.
- If debris is found on the lens, clean the lens. If the lens, bezel, or bezel seal are damaged, replace as necessary.
- Engine running, vehicle in PARK, verify the backup lamps are off.
- If the backup lamps are illuminated, refer to Rearview Camera System Always On below .
- Vehicle in REVERSE, engine running, verify a clear rear vision image is displayed on the radio.
- If a clear image is not displayed, refer to Rearview Camera System Does Not Display below.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.