SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SUBURBAN C2500, 6.0 UREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1614 (ENGINE CONTROLS AND FUEL - 3.6L (LCS) - INTRODUCTION)REPAIR INSTRUCTIONSFUEL FEED PIPE REPLACEMENTINSTALLATION PROCEDURE
2006 Chevrolet Suburban C2500, 6.0 U

Installation Procedure

2006 Chevrolet Suburban C2500, 6.0 USECTION Installation Procedure
WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ensure that the fuel feed pipe and fuel pump fittings are clean and dry prior to assembly.
    2. Fig 1: Identifying Fuel Feed Pipe Components
    GM1977758Courtesy of GENERAL MOTORS CORP.
  2. Position the fuel feed pipe (2) to the cylinder head and high pressure fuel pump.
  3. Install the fuel feed pipe fitting to the high pressure fuel pump hand tight.
    4. CAUTION: Refer to Fastener Caution .
  4. Install the fuel feed pipe bolts (4).
    • Tighten the bolts to 50 N.m (37 lb ft).
    • Tighten the fitting to 28 N.m (20 lb ft).
  5. Connect the fuel feed line quick connect fitting to the fuel feed pipe (2). Refer to Fuel Pipe Shield Replacement .
    6. NOTE: If a fuel leak accrues at the high pressure fuel pump, the pump will need to be replaced.
  6. Inspect for leaks using the following procedure:
    1. Turn ON the ignition, with the engine OFF for 2 seconds.
    2. Turn OFF the ignition, for 10 seconds.
    3. Turn ON the ignition, with the engine OFF.
    4. Inspect for fuel leaks.
  7. Install the low side fuel pressure service port cap.
  8. Install the fuel tank cap.
  9. Install the radiator surge tank outlet pipe. Refer to Radiator Surge Tank Outlet Hose/Pipe Replacement (LY7) .
  10. Install the high pressure pump shield. Refer to Fuel Pipe Shield Replacement .
  11. Install the drive motor generator power inverter module. Refer to Drive Motor Generator Power Inverter Module Removal and Installation
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.