Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SUBURBAN C2500, 6.0 UREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1607 (POWER OUTLETS)DIAGNOSTIC INFORMATION AND PROCEDURESPOWER OUTLET RECEPTACLE INOPERATIVECIRCUIT/SYSTEM VERIFICATION
2006 Chevrolet Suburban C2500, 6.0 U
Circuit/System Verification
2006 Chevrolet Suburban C2500, 6.0 USECTION Circuit/System Verification
WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition ON, connect an AC power extension cord to the accessory power outlet. Inserting the extension cord plug into the accessory power outlet turns the accessory AC/DC power control module ON.
- Test for 110-120 volts AC across the line hot and line neutral terminals of the extension cord.
- Test for 59-61 Hz AC across the line hot and line neutral terminals of the extension cord.
- If not within the specified value, replace the accessory AC/DC power control module.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.