SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SUBURBAN C2500, 6.0 UREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1598 (DISC BRAKE SYSTEM)SPECIFICATIONSDISC BRAKE COMPONENT SPECIFICATIONS
2006 Chevrolet Suburban C2500, 6.0 U

Disc Brake Component Specifications

2006 Chevrolet Suburban C2500, 6.0 USECTION Disc Brake Component Specifications
WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
Application Specification
Metric English
Front Brakes
  • Brake Pad Lining Minimum Thickness
 2.0 mm 0.080 in
  • Brake Rotor Diameter
 296.00 mm 11.654 in
  • Brake Rotor Discard Thickness*
 27.4 mm 1.079 in
  • Maximum Allowable Lateral Runout
 0.06 mm 0.002 in
  • Maximum Allowable Scoring
 1.50 mm 0.059 in
  • Maximum Allowable Thickness Variation
 0.025 mm 0.001 in
Rear Brakes
  • Brake Pad Lining Minimum Thickness
 2.0 mm 0.080 in
  • Brake Rotor Diameter
 191 mm 7.520 in
  • Rotor Discard Thickness *
 18.4 mm 0.724 in
  • Maximum Allowable Lateral Runout
 0.06 mm 0.002 in
  • Maximum Allowable Scoring
 1.50 mm 0.059 in
  • Maximum Allowable Thickness Variation
 0.025 mm 0.001 in
* All brake rotors have a discard dimension cast into them. Replace any rotor that does not meet this specification. After refinishing the rotor, replace any rotor that does not meet the minimum thickness specifications.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.